Well
     This was written to inform SF Sysops Of a Noted Problem
     with sfchkup that I found if you can't run SFCHKUP in
     Win 95 ..Make sure the Memory setting properties are set
     right ...Noted problem XMX Memory should be set to Auto
     And Use High mem area Checked


    A Curupt sffarea.dat file Will Give You Problems to..Like
    If Ya ran Sfchkup /config ,,Twice,, Cure is change the upload
    path to a temp dir then re-run sfchkup /config with the right
    Upload path..   

   Also some other Problems I ran Across At the bottum of Page

                               Jeff Moore  Remote-Sysop of Ameritech
                                           Tele-Tech BBS
                                            Detroit Mi.
                                           (313) 371-2070
_______________________________________________________________________________

I Could get into detail about why this setting take place
but it would drag on..So A Short Story Begins

Some Win 95 Users Use A NOEMS Switch in there Emm366 Memory Manager
witch I highly Sujest!! There just is not enough memory to scan with 
low conventional Memory ..Like McAffe's Scan).. I also use the 
Stackshigh=0,0 and Run Buffershigh=40 and fileshigh=40 
Sysop that have upgraded to Win 95 don't need to use the BRK Driver..
and load your ANSI.SYS HIGH ..Also Share Is not needed it loads automatic..

Some high speed Modem Info
                       I found in Win 95 That turning off the Hardware flow 
control works better for me ..Setting the comport speed to 115200 but setting 
Spitfire to 57600  I have not really Had good luck with Plug & Play Modems..
I also noted a problem with  USR 28.8 Modems Locking up..And Most of the time 
it is in chat mode when it happens,,If anyone has a Cure for this problem 
I would Like to know...
I can Be Reached At..russj@ix.netcom.com  
Or at TeleTech BBs (313)371-2070  Node 1
                        371-2071  Node 2   Has Line Hunt Feature So Nodes   
                        371-2066  Node 3           Are Never Busy   


Well I was On the Subject of Bugs So I'll tell Ya Another one I ran Into
The return in my menu screens laps I had to hit enter after each command 
ie: (F) for file area..I would haft to hit enter after each key stroke
normaly you could just hit (F) in the Main Menu and go right to the file 
menu ..Well I had to hit (F) then Enter to go into the file menu..
the problem was in the sfusers.dat file luckly I had a backup of my   
sfusers.dat file SO I just overwrited the old one...
 